User's Manual
Table Of Contents
- I. Instructions
- 1.1 Safety warnings
- 1.2 Precautions
- II. Main Features
- III. Instructions on technical specifications
- IV. Installation and operation of the printer
- 4.1 Unsealing of the printer
- 4.2 Connection method of the printer
- 4.3 Installation of paper rollers
- V. Switches, buttons and indicator lights of the
- 5.1 Power switch
- VI. Cashbox port of the printer
- VII. Printer cleaning
- 7.1 Clean the printer head
- 7.2 Cleaning sensor
- VIII. Paper jam elimination method
- IX. Malfunction elimination
- 9.1 Indicator light on the control penal fail to
- 9.2 Indicator light function well, but the printer
- X. Printer driver
- 10.1 Driver installation under Windows
- 10.2 Direct drive of serial ports
Ⅻ.Requirement
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.