User's Manual

Installation and pairing of remote control
1.Remote control installation
Installation location: The figure shows the recommended installation location for the remote
control. The installation location can be selected according to the actual use at home.
2. Match remote control
After the battery is loaded into the remote control, it can be used normally.
About 35.4 in
Remote control bracket
STOP
Gear
light
If the product has no action, the remote control can be repaired in the
following ways:
Disconnect the power supply
Press the stop button of the remote control until the gear light flashes
Put the remote control close to the flush button, and then turn on the power
The gear light stops flashing when the match is successful
Drill two holes with a diameter of 6mm on the wall with a depth of more than 45mm, the
distance between two holes is the same as the distance between the installation holes of
the remote control
Insert the two expansion pipes in the accessory package into the two holes on the wall
respectively
Tear open the other side of double-sided adhesive tape, paste the remote control bracket on
the wall, pay attention to align the opening hole of the remote control with the hole on the wall
Fix the remote control bracket with two screws in the accessories package
Open remote control battery cover, put the batteries in and put back battery cover
Place the remote control on the bracket
Installation steps:
9