User's Manual

Installation steps
8
if the angle valve and wall is too close,you
can installed the tee under the inlet valve
tee
hose
inlet valve
hose
angle valve
2
10.Turn on the knob to check whether
the nozzle is protruding；
Normally,the tee is installed on the
angle valve
8.Installation tee；
4
tee
hose
inlet valve
hose
angle valve
9.Open the angle vavle to check for
water leakage；
11.Plugged into a power supply；
In order to protect the internal circuit, be sure to turn on the knob to
make the water run before plugging the device into a power source.
Note