User's Manual

Using remote monitoring function to open the target on the intercom microphone (only the user alias or ID).No
voice or visual indication appeared on the target interphone. You can use the function of remote monitor target
intercom any sound around. Your intercom must programming allows you to use this feature。
Start the remote monitoring
Use the menu function：
1. Press [OK] key enter the menu mode
2. Click [delta or del] key to address book, and then press [0 k] key choice
3. Press [delta or del] to the required user alias or ID, and then press [0 k] key choice.
Or press [delta or del] key to manual dialing, and then press [0 k] key choice.Enter the user alias or ID, and then
press [0 k] key to select.
4. Press [delta or del] key to remote monitoring, and then press [0 k] key choice.
5. Screen remote monitoring: (user alias or ID), indicating the ongoing remote monitor, the LED indicator for the
red light.
6. Screen display remote monitoring successfully. Or screen display remote monitoring failure.
7. If successful, interphone began to receive from the voice of the radio signal monitoring, until the end of the
duration of the preprogrammed, LED light is put out。
Or if not successful: intercom repeating until reach preprogrammed attempts.
The address book set:
Address book for handheld walkie-talkie "address book". Each entry corresponds to an alias or ID used to start
the call。
The address book entries displayed in the following information:
• Call type
•
Call the alias
•
The call ID
Note: you can to digital contacts list to add, delete, or edit contacts。
By the address book caller group shout
1. Press [OK] key enter the menu mode
。
2. Click [delta or del] key to address book, and then press [OK] key choice.
3 . Press [delta or del] to the group name or ID.
4. Hold hand microphones that its in a vertical position and keep mouth 1 to 2 inches (2.5 to 5.0 cm)。
5 . Call press (PTT), the LED indicator for the red light.Screen calls group name or ID, as well as the set of
ICONS.
6. Release (PTT) release button, when any user response within the group, the LED indicator for the green
light.You will see on the screen group call icon user ID.
7. Free prompt if you enable the "channel" function, is when the target radio (PTT) release button, you will hear a
short beep, said this channel is idle, waiting for your answer. Press the call key (PTT) answer. If in a
preprogrammed group called hang time without voice activity, the call is terminated.
Single call initiated by the address book
1. Press [OK] key enter the menu mode
。
2. Click [delta or del] key to address book, and then press [OK] key choice
3. Press [delta or del] to the required user alias or ID
Or press [delta or del] key to manual dialing, and then press [OK] key choice.
Or press [delta or del] key to manual dialing, and then press [OK] key choice, using the keyboard to enter a new
ID.