User's Manual

To comply with RF exposure requirements, a minimum separation distance of 80cm

80 cm

PRECAUTIONS

Observe the following precautions to prevent ﬁ re, personal injur

y, and transceiver

damage.

• Do not attempt to conﬁ gure the transceiver while driving; it is too dangerous.

• Do not disassemb

le or modify the transceiver for any reason.

• Do not expose the transceiver to long periods of direct sunlight, nor place it near heating

appliances.

• If an abnormal odor or smoke is detected coming from the transceiver, switch the

transceiver power off immediately, and contact your COVALUE dealer.

• Use of the transceiver while you are driving may be against trafﬁ c laws. Please check

and observe the vehicle regulations in your area.

• Do not use options not speciﬁ ed by .

◆ The transceiver operates in 12 V negative ground systems only! Check the battery polar

ity and

voltage of the vehicle before installing the transceiver.

◆ Use only the supplied DC power cable or a optional DC power cable.

◆ Do not cut and/or remove the fuse holder on the DC power cable.

For passenger safety, install the transceiver securely using the supplied mounting bracket and

screw set so the transceiver will not break loose in the event of a collision.

COVALUE

Antenna requirement:

The device should not be installed with an antenna greater than 0 dBi.

Maintain a s

eparation distance from the antenna to person(s) of

at least

is required between antenna and all public persons. The device should not

be installed with an antenna greater than 0 dBi.