User's Manual

When the repeater does not work, or when the intercom located outside the scope of the repeater but in
other intercom call scope, you can continue to communication.This is the so-called "net".
According to the relay/net off key, in the process of the programming switching between network and relay
mode.
Use the menu function
1. Press [OK] key to enter the menu mode.
2. According to the [delta or del] key to set up, and then press [0 k] key choice.
3. Press the [delta or del] key to radio set, and then press [0 k] key choice.
4. Press [delta or del] to take off the net, and then press [0 k] key choice.
5. If the intercom current is in the repeater mode, you can see the open, or if the intercom current in the
network mode, you can see close.
6. Press [0 k] key to choose.
7. The screen to take off the net open, closed or screen net.
8. Automatically return to the previous menu screen.
Even after shutdown, remain to take off the network Settings.
1. The mode selection
1. Press [OK] key to enter the menu mode.
2. According to the [delta or del] key to set up, and then press [0 k] key choice.
3. Press the [delta or del] key to radio set, and then press [0 k] key choice.
4. Press [delta or del] to the model, and then press [0 k] button to enter submenu.
5. Press [delta or del] choose channel model or frequency model, and then press [OK] key.
Set the level of noise
You can adjust the radio noise level, filter low signal intensity of unwanted calls or background noise is higher
than the normal value of the channel.Setting: normal is the default value, strict filtering (useless) call or
background noise.Calls from a remote location, however, may also be filtered out.
Press preprogrammed strict/normal noise in the switching between normal and strict noise level.