User's Manual

5. The display shows Turn On. Press [OK] to enable the Introduction
Screen. The display shows Intro Screen On. OR the display shows
Turn Off. Press [OK] to disable the Introduction Screen. The
display shows Intro Screen Off.
Accessing General Radio Information
Your radio contains information on the following:
 Radio ID
 Software version
 Codeplug Version
NOTE: Press [BACK] at any time to return to the previous screen.
Checking the Radio ID
Procedure:
1. Press [MENU] to access the menu
2. Press to Utilities and press [OK] to select.
3. Press to Radio Info and press [OK] to select
4. Press to My Number and press [OK] button.
5. The display shows radio ID and alias
Checking the Firmware Version
Display the firmware version on your radio.
Procedure:
1. Press [MENU] to access the menu.
2. Press to Utilities and press [OK] to select.
3. Press to Radio Info and press [OK] to select.
4. Press to Firmware Ver. and press [OK] button.
5. The display shows the current firmware version.
Checking the Codeplug Version
Display the codeplug version on your radio.
Procedure:
1. Press [MENU] to access the menu.
6. Press to Utilities and press [OK] to select.
7. Press to Radio Info and press [OK] to select.
8. Press to CP Ver. and press [OK] button.
2. The display shows the current codeplug version.
o
r
o
r
o
r
o
r
o
r
o
r
o
r
o
r
o
r
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to