User's Manual

FCC STATEMENT 
1. This device complies with Part 15 of the FCC Rules and Industry Cana da licence-exempt RSS
standard(s) . Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This devi ce m ust acc ept any interference rece ived, including interference that m ay caus e
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a C lass B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provi de reasonable protection
against harmful interference in a res idential installation. This equipment generates, uses an d can
radiate radio frequency energy and, if n ot installed and used in accordance with the instructions,
may cause h armful in terference t o ra dio com munications. H owever, th ere is n o guarantee that
interference will not occur in a particular i nstallation. If this e quipment do es cause h armful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is enc ouraged to try to c orrect the interference by one or m ore of the fol lowing
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the e quipment into an outlet on a circuit d ifferent from that t o w hich the rece iver i s
connected.
—Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, Human proximity
to the antenna shall not be less than 20cm (8 inches) during normal operation.
.
This equipment complies with FCC radiation limits set forth for an uncontrolled environment.This
equipment mush not be co-located or operating with any other antenna or transmitter. This module
is designed to comply with FCC statement FCC ID is: 2ADID-WP0DR1110. The host system using
this module should have label in a visible area in dicated the following texts "Contains FCC ID :
2ADID-WP0DR1110".