User's Manual

Basic Operations

Note: If the screen does not receive a displaying signal for a certain time, the screen goes into standby mode.

Plug the power cord into an AC Power outlet. Press Power Switch on the screen.

Now the screen is in standby mode. Wait a moment until the power indicator lights up, then press POWER to

turn on the screen. (Be sure to wait for a few seconds before pressing POWER button. If you promptly press

POWER button then the screen may not respond or act wrongly.)

Press button again to turn off the screen and put the screen in standby mode.

To cut off the power completely, press Power Switch on the screen.

Turning the screen on or off

Operating the Float menu

The first time installation

Connect to power source and turn on the screen, the below installation menu page will display on the screen.

Select desired menu

language, then press START

and go to next page.

Select location and go to

next page.

1.Slide up from bottom of the screen center by two or more fingers to call .

Press and drag to any place of the screen.

2. Press to take 2 seconds to be activated in VGA/HDMI/DP/PC mode.

3.When displaying at USB interface, touch once at the lower part of the screen, the display

control menu will appear.

Call the Volume bar

Call the input source menu

Back to previous

Turn off the screen

Call the application history

Call the Home page (Android Interface)

Call the annotation