User's Manual

Basic Operations
Turning the display on or off
To turn the display on or off:
Plug the power cord into an AC power outlet.
Now the unit is in standby mode. Wait a few seconds until the power indicator lights
up and press POWER to turn on the display. (Be sure to wait a few seconds
before pressing POWER button. If you promptly press POWER button then
the display may not respond.
Press POWER button again to turn off the display and put the display in standby
mode.
To completely disconnect power, unplug the power cord.
1
2
3
11
Note: If the display does not receive a broadcast signal for several minutes, the mpnitor
will automatically turn off and go into standby mode.
Selecting the input source
To select the input source:
1
Press the INPUT button.
Press 6or 5to select the input source. Options include:
2
Adjusting the volume
! Press VOL+ or VOL- to increase or decrease the volume.
! Press the MUTE button to temporarily turn off the sound. To restore the sound, press
the VOL+ or MUTE button.
Note: The speaker volume and the headphone volume will be memorized separately.
To adjust the volume:
Displaying program
information
To display program information:
AV — Watch the AV signal.
COMP. — Watch the signal from the COMPONENT input terminals.
!VGA — Watch the signal from the VGA input terminal.
!HDMI 1 — Watch the signal from the HDMI1 input terminal.
!HDMI 2 — Watch the signal from the HDMI2 input terminal.
Press OK to confirm the selection.
3
You can press the DISPLAY button to display current program information such as
channel number, color/audio system, or video input source, etc. To clear the display, press
this button again or wait a few seconds and it disappears automatically.
Freezing the Picture
Press the FREEZE button to freeze the image on the screen (the video sources still run).
Press this button again to reactive the image.
Note:
! If a fixed image is displayed on the screen for a long time, that fixed image may become imprinted on the screen and
remain visible. Therefore do not freeze the picture for a long time.
! In some modes, the FREEZE function can not work.
To freeze the picture:
AV
COMP.
VGA
HDMI 1
HDMI 2
Input Source
Select
Move
HDMI 1
HDMI 2
USB
Ser vice on ly
USB
TOUCH
RS-232 1
RS-232 2