PRODUCT SPECIFICATION Bluetooth 4.0 Module Model Number: BT03B110 (Broadcom BCM20705) 客户认可 Custom Approval Section Custom Name Department Approval Xiamen Prima Technology Inc Date：２０１６－０５－０６ Version 2.
PRODUCTS SPECIFICATION BT03B110 Document revision history Revision Date Approved by Remarks Version 1.0 2014-04-22 Draft Version 2.0 2014-12-23 Company name changed PAGE 2 OF 6 Version 2.
PRODUCTS SPECIFICATION 1. BT03B110 General Description This document is to specify the product requirements for Bluetooth 4.0 Module. This Card is based on Broadcom BCM20705 chipset that can support BT2.1+EDR/BT3.0+HS and BT4.0+EDR. 2. Features z z z z z z z z Bluetooth 4.0+EDR compliant Programmable output power control meets Class1,Class2,or Class3 requirements. Use supply voltages up to 5.5V. Supports Broadcom SmartAudioTM,wide-band speech,SBC codec,and packet lose concealments.
PRODUCTS SPECIFICATION BT03B110 3.2 General Requirements 3.2.1 Electrical Characteristics Feature Detailed Description 3.2.1.1 Radio and Modulation Schemes ● GFSK,8DPSK,pi/4DQPSK 3.2.1.2 Operating Frequency ● 2402 ～ 2480 MHz in the ISM band 3.2.1.3 Channel Numbers ● 79 channels 3.2.1.4 Symbol Rate ● 1Mbps 3.2.1.5 Carrier Spacing Transmitter Output Power at Antenna Connector Receiver Sensitivity at Antenna Connector ● 1.0MHZ ● -4~+6dBm ● ≤-80dBm 3.2.1.
PRODUCTS SPECIFICATION 4. 4.1 Thermal Characteristics Temperature Limit Ratings Parameter Storage Temperature Ambient Operating Temperature Junction Temperature 4.2 Minimum -25 -10 0 Maximum +85 50 125 Units ℃ ℃ ℃ Mechanical Requirements 4.4.1 4.4.2 4.4.3 4.3 BT03B110 Feature Length Width Height Detailed Description ● 16mm ● 12mm ● 1.0mm(PCB) Mechanical Dimensions PAGE 5 OF 6 Version 2.
PRODUCTS SPECIFICATION 4.4 Pin Description Pin No 1 2 Name GND NC 5. 3 NC 4 NC 5 GND 6 D+ 7 D- 8 Vcc BT03B110 9 RST Name rule BT03B110 Model name X Memory：F—FLASH；R—ROM；Empty—No Memory PAGE 6 OF 6 Version 2.
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
When OEG purchase the module, they can only buy this antenna to match the modules The max antenna gain of antenna is 2dBi.
