User's Manual

7
STEP 5:
Attach the Sliding Rail (No. 5) to Main
Frame (No. 1) using 6 Screws (No. 55)
and 6 Washers (No. 60). Tighten and
secure with Allen Wrench (No. 74).
STEP 7:
NOTE: The two upper buckles of
Computer (No. 32) should be aligned to
the two upper slots of computer seat of
Main Frame (No. 1).
Connect Sensor Wire (No. 34) with the
wire of Computer (No. 32). Place
Computer (No. 32) back onto the Main
Frame (No. 1), then push the Computer
(No. 32) downwards to fit into position.
The assembly is complete!
STEP 6:
Take out 2 AAA batteries from the plastic
bag with the manual. Push Computer (No.
32) upward, then remove Computer (No.
32) from Main Frame (No. 1). Disconnect
Sensor Wire (No. 34) and the wire of
Computer (No. 32). Install the 2 AAA
batteries into the back of Computer (No.
32).