User's Guide

14
triggered.
Is continued for: the updated value should last for some time that is longer
than a sole reporting interval.
Set lockout time: after the lockout time, UC100 will check if the latest RS485
response matches the condition still. 0 means this IF condition will only be
detected once.
Received a D2D
control
command
This only works with the LoRa D2D feature enabled. See details on chapter 4.5.
3. Set THEN action according to your request. You can add at most 3 actions in one command.
Action
Description
Send a LoRaWAN
message
Send a custom message to the network server.
Restart the Device
Reboot the device.
Send a D2D control
command
This only works with LoRa D2D feature enabled. See details on chapter 4.5.
Send a Modbus
command via the
RS485 interface
This only works with LoRa D2D feature enabled. See details on chapter 4.5.
4.5 LoRa D2D Settings
LoRa D2D protocol is developed by Milesight and used for setting up transmission among
Milesight devices without a gateway. When the LoRa D2D setting is enabled, UC100 can work as
a LoRa D2D controller to send control commands to other devices or work as a LoRa D2D agent
to receive commands to trigger a reboot or message to the network server.
1. Go to “General -> Basic” page, enable LoRa D2D feature, and define a unique LoRa D
2D key which is the same as LoRa D2D controller or agent devices. (Default LoRa D2D
Key: 5572404C696E6B4C6F52613230313823)