User's Manual

USER MANUAL USER MANUAL
1817
User authorization
Connect to Vehicle Charging Inlet
Charging Message
Charging completed
9. Operation Instuctions
9.1 Operating Procedures
9.2 Operating Steps
Step 1 / Standby Mode
After power-on, blue light (READY), green light (CHARGE) and red light (FAULT) all lit.
Enter standby mode and the blue light (READY) is steady on.
READY
Step 2 / Tap the RFID Card
Please plug the charging connector into the vehicle charging inlet. When you tap the
RFID card first, it needs to complete the insertion of the charging connector within 120
seconds, otherwise you need to tap the RFID card again.
Step 4 / Charging
The green light (CHARGE) turns to flash automatically, charging is in process.
• If the red light (FAULT) is lit, plug the vehicle connector again.
• If red light is still lit, please refer to "Error and Warning Messages".
CHARGE
Step 3 / Tap the RFID Card
Tap the RFID card to start the charging.
Step 5 / Charging Finished
When the charging is finished, the green light (CHARGE) is constantly lit, please
press the button on connector.