Electric Vehicle AC Charger EVC Series (NA) - User Manual
USER MANUAL USER MANUAL WARNING WARNING 1. Important Safety Instructions AVERTISSEMENT – Ce manuel contient des instructions importantes pour les modèles : série EVC10 qui doit être suivie pendant l'installation, le fonctionnement et la maintenance de l'unité. WARNING – This manual contains important instructions for Models: EVC10 series that shall be followed during installation, operation and maintenance of the unit. 1) Read all the instructions before using this product.
USER MANUAL USER MANUAL WARNING 2. Basic Interface This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
USER MANUAL USER MANUAL 3. Dimensions 4. Design Standard UL 2594: Electric Vehicle Supply Equipment UL 2231-1: Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: General 9.8″ 5.
USER MANUAL USER MANUAL 5. Specification 6. Status Description of the Charger Indication Light EVC Version Model Name Rated Input Voltage 200-240 VAC / Single Phase Rated Output Current 16/32/40/48A AC Power Frequency 60 Hz Input Protection Output Protection Output Interface UVP, OVP, RCD, SPD, Ground Fault Protection The READY light stays steady in standby mode.
USER MANUAL USER MANUAL No. Fault - Red Light FAULT The red light is lit while fault. Please refer to "9.3 Error and Warning Messages" for detailed information. 7. Packing List Product Name Quantity Note 1 AC Charger (With Charging Cable) 1 2 User Manual 1 3 Wall-Mounted Bracket 1 4 M5 teeth screws 2 5 M6 Hexagonal Expansion Screws 4 6 RFID Card (RFID Version Only) 2 8 Installation Instructions Electric Vehicle AC Charger 8.
USER MANUAL USER MANUAL 8.2 Installation Steps Step 3: Tighten 13 screws on the front cover after the front cover is put back, the Step 1: Use screwdriver to loosen the 13 fixed screws on the rear of charger, recommended screw torque is 1.0 N.m (9.6 lbf.in) (for 4G Version). 8 then remove the front cover (for 4G Version). 8 7 6 4 10 3 11 2 13 6 5 9 4 10 3 11 2 5 9 12 7 12 13 1 1 8.3 Wiring Step 2: Insert the SIM card according to the picture's instruction (for 4G Version)..
USER MANUAL USER MANUAL 8.4 Tools and Materials Required For safe use of electricity, please add circuit breaker protection in the input part of charging pile. Connect the L1 lead to the grid L1, connect the L2 lead to the grid L2, Tools required before installing the Wall-Mounted charger, gather the following tools: connect the PE lead to the grid PE (for all Version). • Wire stripper • Crimpers for European terminals • Phillips screwdriver for M5 • Slotted screwdriver for 4~5.
USER MANUAL 8.5 Wall-Mounted Bracket Installation USER MANUAL Step 3: Fix two M5 screws to complete the installation. Step 1: • Set the positions of the 4 screw holes and drill them, with a diameter of 8mm and a depth of 52mm. • Use 4 sets expansion screw and M6 screw to fix the wall-mounted bracket on the wall.
USER MANUAL USER MANUAL 9. Operation Instuctions Step 3 / Tap the RFID Card Tap the RFID card to start the charging. 9.1 Operating Procedures User authorization Connect to Vehicle Charging Inlet Charging Message Charging completed 9.2 Operating Steps Step 1 / Standby Mode After power-on, blue light (READY), green light (CHARGE) and red light (FAULT) all lit. Enter standby mode and the blue light (READY) is steady on.
USER MANUAL USER MANUAL 10. Maintenance and Repair 9.3 Error and Warning Message Status Red Remark 10.1 Daily Maintenance Please keep the charger clean and keep the charge in a clean area with low humidity.
USER MANUAL USER MANUAL • During the warranty period for any malfunction caused by normal use according to the User Manual and Service Instruction (to be determined by certified maintenance technicians of Joint Technology), the product shall be repaired free of charge. Except for the following situations, the charger shall be subject to the above warranty terms: 1.