User Instructions

7.4 Wall-Mounted Bracket Installation7.3 Tools and Materials Required
Tools required before installing the Wall-Mounted charger, gather the
following tools:
Wire stripper
Crimpers for European terminals
Phillips screwdriver for M5
Slotted screwdriver for 4~5.5MM
Adjustable Wrench M6
Head gasket screw 10-10.5mm
Voltmeter or digital multimeter (for measuring AC voltage at the installation site)
The inserting cable should meet the best waterproof performance. It is recommended to use
3 core / 7AWG cable (XLPE or equivalent cable) to pull the cable from the
distribution box.
Level ruler
Pencil or marker
Machine drill
“This device shall be mounted at a sufficient height from grade such that the height of the
storage means for the coupling device is located between 600 mm (24 inches) and 1.2 m (4
feet) from grade.”
“This device shall be mounted at a sufficient height from grade such that the height of the
storage means for the coupling device is located between 450 mm (18 inches) and 1.2 m (4
feet) from grade.”
Step1 :
• Set the positions of the 4 screw holes and drill them, with a diameter of 9mm and
a depth of 52mm.
• Use 4 sets expansion screw and M6 screw to fix the wall-mounted bracket on the wall.
Step2 :
Align the rear notch of charger into the wall-mounted bracket and fit the screw
holes of the right and left side.
INSTALLATION INSTRUCTIONINSTALLATION INSTRUCTION
1413
Installation Instructions