User Instructions

When the charging is finished, the blue light (CHARGE) is constantly lit, press the
button on connector to stop the charging.
STEP5 / Charging Finished
Tap the RFID card to start the charging.
STEP3 / Tap the RFID Card
8.3 Error and Warning Message
Status Blue Green Red Remark
Input OVP
- -
1 flashes followed
by 3 sec pause
Auto Recover
Input UVP
- -
2 flashes followed
by 3 sec pause
Auto Recover
Output OCP
- -
3 flashes followed
by 3 sec pause
Auto Recover
OTP
- -
4 flashes followed
by 3 sec pause
Auto Recover
RCD Abnormal
- -
5 flashes followed
by 3 sec pause
Auto Recover
Ground Fault
- -
6 flashes followed
by 3 sec pause
Auto Recover
Control Pilot Fault
- -
Flicker
Auto Recover
MCU Self-Test Fail
- -
Constantly
Bright
Contact Customer
Service
RCD Self-Test Fail
- -
Constantly
Bright
Contact Customer
Service
Relay Self-Test Fail
- -
Constantly
Bright
Contact Customer
Service
RCD Abnormal
St
op Charging
-
-
-
-
Constantly
Bright
Contact Customer
Service
Output OCP
Stop Charging
-
-
Constantly
Bright
Contact Customer
Service
OTP
Stop Charging
Constantly
Bright
Contact Customer
Service
INSTALLATION INSTRUCTIONINSTALLATION INSTRUCTION
2221
The green light (CHARGE) turns to flash automatically, charging is in process
• If the red light (FAULT) is lit, re-plug the vehicle connector again.
• If red light is still lit, please refer to "Error and Warning Messages".
STEP4 / Charging
9.1 Daily Maintenance
Please keep the charger clean and keep the chager in a clean area with low humidity. Do not
install it in an environment near the sea, high humidity or high dust.
• Avoid moisture or water in the charger. If there is water or moisture ingress into the charger, it
is necessary to immediately power off to avoid immediate danger, and notify the professional
personnel to carry out maintenance before next use.
• If there is any damage or dirt on the vehicle connector, charging cable, or vehicle connector
holder, please contact the maintenance personnel immediately.
• Please use the charger properly. Do not hit or press hard on the case. If the case is damaged,
please contact a professional technician.
9. Maintenance and Repair
READY