User Instructions

8.2.2 Operating Steps With RFID
Please plug the charging connector into the vehicle charging inlet.
STEP2 / Plug In
After power-on,,blue(READY) ,green(CHARGE) and red light (FAULT) all lit. Enter
standby mode and the blue light (READY) is steady on.The time from power on to
the green light on is 90 seconds.
STEP1 / Standby Mode
INSTALLATION INSTRUCTIONINSTALLATION INSTRUCTION
2019
When the charging is finished, the blue light (CHARGE) is constantly lit, press the
button on connector to stop the charging.
STEP4 / Charging Finished
The green light (CHARGE) turns to flash automatically, charging is in process
• If the red light (FAULT) is lit, plug the vehicle connector again.
• If red light is still lit, please refer to "Error and Warning Messages".
STEP3 / Charging
READY
READY