Installation Instructions

8.2 Operating Steps
Please plug the charging connector into the vehicle charging inlet. when you tap the
RFID card first, it needs to complete the insertion of the charging connector within 180
seconds, otherwise you need to tap the RFID card again.
STEP2 / Tap the RFID Card
After power-on,,blue(READY) ,green(CHARGE) and red light (FAULT) all lit. Enter
standby mode and the blue light (READY) is steady on.The time from power on to
the green light on is 90 seconds.
STEP1 / Standby Mode
READY
When the charging is finished, the blue light (CHARGE) is constantly lit, press the
button on connector to stop the charging.
STEP5 / Charging Finished
Tap the RFID card to start the charging.
STEP3 / Tap the RFID Card
INSTALLATION INSTRUCTIONINSTALLATION INSTRUCTION
2019
The green light (CHARGE) turns to flash automatically, charging is in process
• If the red light (FAULT) is lit, plug the vehicle connector again.
• If red light is still lit, please refer to "Error and Warning Messages".
STEP4 / Charging
CHARGE