User's Manual

5
humantouch.com
4
5
ENGLISH
Your Human Touch Gravis ZG chair requires some simple
assembly. Just attach the armrests, body pad, head pillow,
remote pocket, and you’re done!
get ready
1. Plug in the chair, then use the controller Back and Foot buttons to raise the backrest and lower
the legrest.
3. Turn the armrest over, lower it onto the chair arm, then slide it forward as far as it will go. The locking
mechanism clicks into place.
4. Repeat steps 2 and 3 to install the other armrest.
5. Pull up and backward on each armrest to make sure it is locked into place.
INSTALL THE ARMRESTS
Chair Base
Body Pad
Head Pillow Remote Pocket
Unpack the box
Armrests (2)
Power Transformer/Cable
Legrest
Backrest
2. Align the armrest as shown below, with the armrest tabs positioned to the rear of the corresponding
tabs on the chair arm.
ArmrestArmrest tab
Chair tab
Chair tab
Armrest tab