User's Manual

5
6. Things to Be Noted About the Power Plug and Cord
• Check that the Alternating Current (AC) voltage corresponds with the specifications
indicated for the massage chair.
• Do not connect or disconnect the power plug from the electrical outlet with wet hands.
This may result in malfunction or electric shock.
• When disconnecting the power plug, pull it by holding the plug, not the cord.
• Although operation will be stopped automatically by the Auto-Timer function, always
remember to switch off the main power after use.
• Do not place the power cord under the massage chair or any other heavy objects.
• Do not wind the power cord around the massage chair as this may damage the cord and
result in a fire or electric shock.
• Do not operate the massage with a damaged cord or extension cord.
• Do not use the massage if the electrical outlet is loose.
• If the power cord is damaged, it should be replaced by a qualified technician.
7. Temperatures sufficiently high to cause burns may occur regardless of the control
setting.
• Do not use on an infant or invalid or on a sleeping or unconscious person.
• Do not use on insensitive skin or on a person with poor blood circulation.
• Check the skin in contact with the heated area of the appliance frequently to reduce the
risk of blistering.
• Do not operate under blanket or pillow. Excessive heating can occur and cause fire, electric
shock, or injury to persons.
• Do Not Crush – Avoid sharp folds.
• Do not use massager in close proximity to loose clothing or jewelry.
• Keep long hair away from massager while in use.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
Warning
BURNS WILL RESULT FROM IMPROPER USE
READ INSTRUCTIONS BEFORE USING
DO NOT WET – DO NOT USE PINS
NEVER REMOVE COVER.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposurere quirement.
The device can be used in portable exposure condition without RF striction.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :
1) L'appareil ne doit pas produire de brouillage;
2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
This equipment should be installed and operated with minimum
distance 20cm between the radiator&your body.