Specifications

Taurus Series Multimedia Player T60 Specifications
www.novastar.tech
3
Name
Description
Requirements for full-screen scaling in synchronous mode:

64 pixels ≤ video source width ≤ 2048 pixels

Images can only be scaled down and cannot be scaled up.
WiFi
Wi-Fi antenna connector
Support for switching between Wi-Fi AP and Wi-Fi Sta
ETHERNET
Gigabit Ethernet port
Capable of connecting to a LAN, public network, or computer for content publishing and
screen control
Indicator status description:

The yellow stays on: The T60 is connected to a fast Ethernet cable and the connection is
available.

The green and yellow stay on simultaneously: The T60 is connected to a Gigabit Ethernet
cable and the connection is available.
COM 2
GPS antenna connector
USB 3.0
USB 3.0 (Type A) port
Allowing for playback of content imported from a USB drive and firmware upgrade over
USB
The Ext4 and FAT32 file systems are supported. The exFAT and FAT16 file systems are
not supported.
COM 1
Reserved
AUDIO OUT
Audio output connector
POWER
Power input connector
RELAY
3-pin relay control switch

DC: Maximum voltage and current: 30 V, 3 A

AC: Maximum voltage and current: 250 V, 3 A
Two connection methods:

Common switch: The connection method of pins 2 and 3 is not fixed. Pin 1 is not
connected to the wire. On the power control page of ViPlex Express, turn on the circuit to
connect pin 2 to pin 3, and turn off the circuit to disconnect pin 2 from pin 3.

Single pole double throw switch: The connection method is fixed. Connect pin 2 to the
pole. Connect pin 1 to the turn-off wire and pin 3 to turn-on wire. On the power control
page of ViPlex Express, turn on the circuit to connect pin 2 to pin 3 and disconnect pin 1
form pin 2, or turn off the circuit to disconnect pin 3 from pin 2 and connect pin 2 to pin 1.
Note: The T60 uses DC power supply. Using the relay to directly control AC is not
recommended. If it is required to control AC, the following connection method is
recommended.