Specifications
Table Of Contents
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
1.1 List of applicable FCC rules
FCC Part 15 Subpart C 15.247 & 15.209
1.2 Specific operational use conditions
The module is a 2.4G WiFi module.
Operation Frequency: 2412-2462MHz
Number of Channel: 11
Modulation: DSSS, OFDM
Type: Helix Antenna
Gain: 5.03 dBi Max.
The module can be used for mobile or portable applications with a maximum 5.03dBi antenna.
The host manufacturer installing this module into their product must ensure that the final
composit product complies with the FCC requirements by a technical assessment or evaluation to
the FCC rules, including the transmitter operaition. The host manufacturer has to be aware not to
provide information to the end user regarding how to install or remove this RF module in the
user's manual of the end product which integrates this module. The end user manual shall
include all required regulatory information/warning as show in this manual.
1.3 Limited module procedures
Not applicable. The module is a Single module and complies with the requirement of FCC Part
15.212.
1.4 Trace antenna designs
Not applicable. The module has its own antenna, and doesn’t need a host’s printed board
microstrip trace antenna etc.
1.5 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained
between the antenna and users’ body; and if RF exposure statement or module layout is changed,
then the host product manufacturer required to take responsibility of the module through a
change in FCC ID or new application. The FCC ID of the module cannot be used on the final
product. In these circumstances, the host manufacturer will be responsible for re-evaluating the
end product (including the transmitter) and obtaining a separate FCC authorization.
1.6 Antennas
Antenna Specification are as follows:
Type: Helix Antenna
Gain: 5.03 dBi
This device is intended only for host manufacturers under the following conditions: The
transmitter module may not be co-located with any other transmitter or antenna; The module
shall be only used with the internal antenna(s) that has been originally tested and certified with
this module. The antenna must be either permanently attached or employa ‘unique’ antenna