XGuard IntelliSwitch Power Switch - Manual
Table Of Contents
Page: 8 Copyright 2020 XGuard RC. All rights reserved
XGuard IntelliSwitch
Program an unused channel like AUX1 to be controlled by a
switch. Use this channel to turn on or of the locator buzzer by
plugging it to the top port as shown below.
LOCATOR ALARM SWITCHED ON BY RADIO SWITCH
Turn locator buzzer
on by using the
radio switch
If you want to control the
locator buzzer plug a switched
channel into the switch’s top port
Connect the servo wires to
two receiver/FBL ports
ON
OFF
Three
Position
Switch
ON
OFF
Two
Position
Switch
Note: If the positions are reversed go to the radio’s
setting screen and reverse the switch channel.