XGuard IntelliSwitch Power Switch - Manual

Table Of Contents

XGuard IntelliSwitch

To enter programming mode: Starting from a disconnected Battery state power-up

the switch and click once the ON-button and quickly once again and hold for at

least three seconds then release and listen to the musical tone that indicates program

mode entered.

Right away after the musical tone you will hear one beep then two beeps and so on un

til 6 beeps. If you click the button once after hearing the number of beeps that matches

the programming setting you want it will select the type of battery and warnings as de-

scribed in the list above from 1 to 6 and conrmation beeps matching the one you se-

lected are played. Factory default is mode 1 beep for 2S Lipo with audible warnings.

After selecting your mode the unit will play SEVEN HIGH PITCH beeps to let you select

if you want to ignore the locator buzzer switch signal from the radio. If you click to se-

lect this then the locator alarm will not be active with the switch.

Once you selected both your battery type/warning mode and whether you want

the locator switch ignored or not you will hear another musical tone indicating

that the unit is out of the programming mode and into normal operation.

• Plug Battery

• Press button once and then immediately press again and hold for 3 seconds

• Wait for musical tones indicating programming mode starts

• Wait until number of beeps you want play and press button once to select

• Wait for the same number of beeps as conrmation

• Wait for 7 beeps and if you want to ignore the locator alarm switch press once

• If pressed after 7 beeps then wait for 7 conrmation beeps

• Wait for musical tones indicating programming mode exit

IMPORTANT NOTE: Programming can only be

started by plugging a battery not from Standby.

ENTERING PROGRAMMING MODE

QUICK PROGRAMMING SEQUENCE GUIDE