Certification Exhibit FCC ID: VEYXMODR2 FCC Rule Part: 15.247 ACS Project: 13-2112 Manufacturer: xG Technology, Inc. Model: xMod User Manual 3998 FAU Blvd.
xMod Quick Start Guide
xMod 2.5 Quick Start Guide Table of Contents Introduction........................................................................................................................................... 3 Box Contents.......................................................................................................................................... 3 Hardware Overview..............................................................................................................................
xMod 2.5 Quick Start Guide Introduction The xMax xMod device is a wired/wireless bridge between xMax and 802.11 protocols. It allows WiFi enabled devices to connect to an xMax network. This manual provides basic operations instructions for the unit. Box Contents The xMod device is shipped with the following items. xMod Device Ac Adaptor Ethernet Cable USB to USB Micro Cable Hardware Overview The xMod device is a self contained 802.11b/g access point and xMax modem. The xMod 802.
xMod 2.5 Quick Start Guide The xMod device has 2 LEDs, a status LED and Power LED. The definition of the LED states is listed below. Power LED Solid Green- Device Powered Status LED Solid Green- Registered with system Flashing Green- Registering Orange- No xMax signal Red- Device Fault Device Fault Configuring the xMod for the First Time • • • • • • • • • • Connect the power cord to the AC adaptor. Plug the AC adaptor into the barrel connector on the xMod device.
xMod 2.5 Quick Start Guide Using a WiFi enabled device, configured for DHCP operation, connect to the SSID and password that was configured in the previous step. When connected you are able to begin data operations like web browsing. Alternately configure a PC or tablet interface for DHCP operation. Connect Ethernet or USB cable to the xMod and begin data operations.
xMod 2.5 Quick Start Guide Safety Notices • • • • Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. Warning: Electrical Safety Information • Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label.
xMod 2.5 Quick Start Guide RF Exposure “This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.” Warning: Changes or modifications to this device not expressly approved by xG Technology could void the user’s authority to operate the equipment.
xMod 2.5 Quick Start Guide Because it is impossible for xG to know the purposes for which the purchaser acquired this Product or the uses to which this Product will be put, the purchaser assumes full responsibility for the selection of the Product for its installation and use.