Installation and Operating Manual

12
BSN250 Guide
xG Technology Inc. Proprietary and Confidential Information
Address Configuration
In the Address Configuration section, enter the following information:
IP Address: Enter the planned IP address of the BSN-250 on the Ethernet interface. This address is static
and the format is per IETF conventions: 111.222.333.444. Consult your network administrator for the IP
Subnet Mask: Enter the subnet mask for the Ethernet interface. Consult your network administrator for the
subnet mask assigned to the network.
Gateway IP Address: Enter the IP address of the gateway device on the backhaul metropolitan network
that provides access to other devices on the network, such as the xMSC. This address is static and the format
is per IETF conventions: 111.222.333.444. Consult your network administrator for the IP address of the
gateway.
Signaling Controller IP Address: The Signaling Controller controls SIP signaling between handsets or
other voice devices, and the VoIP core. Enter the default virtual IP address for the Signaling Controller, as
recommended by xG Technology (for example, 10.0.16.15). Consult your network administrator to confirm
the IP address of the Signaling Controller.
xMAX Configuration
In the xMAX Configuration section, enter the network and tower IDs:
Network ID: Enter the network ID allocated by xG Technology to this network.
Tower ID: Enter the tower ID allocated by local network planning to this BSN-250. Consult your local
network planner for the tower ID.
Field Test Mode
To enable field testing, select Enable Field Test Mode. This will prevent handsets from associating with the
base station.
Time Zone
To set the correct time for handsets, select the time zone of the physical site where the base station is located.
Optionally, specify that the time should be adjusted for Daylight Savings Time.
address assigned to this BSN-250.