Installation and Operating Manual

11
xG Technology Inc. Proprietary and Confidential Information
NOTE: If the Web configuration interface does not start, open the base station’s command line and use the ps
command to confirm that the Web server module is running. See Diagnostics and Troubleshooting
for more information.
The Information screen shows some of the base station’s fixed and configurable settings. Fixed factory set-
tings include version and server information. Use the menu on the left side of the interface to configure
network, cable, and channel settings and to run diagnostics, view logs, and upgrade software.
Network Settings
Using the Web configuration interface menu, click Network Settings. This screen is used to enter IP
addresses and information about the xMAX network, enable field testing, and to set the time zone for
handsets (see Figure 5). After entering the appropriate values on this screen, click Apply to save settings, or
Cancel to return to the prior settings.
Figure 5: Web Configuration Interface – Network Settings Screen