User Manual

12
CN3200 Dual Band Routing Modem - Installation Guide - G7604 - Release 1.0
These steps set up the CN3200 Dual Band Routing Modem for use.
After completing these configuration steps, the CN3200 Modem will be fully functional and ready
for operation. It will broadcast on the configured channel. The CN3200 Modem will provide any
Internet-ready device the ability to connect wirelessly to the xMax network, using a secure
connection on a connected WiFi router.
Devices may also be connected to the xMax network through a wired Ethernet connection to the
CN3200 Modem.
For more information, see Wired Internet Connectivity and Setting Up a WiFi Hotspot on page 21.
NOTES
 This procedure should be completed before installing the CN3200 Modem in a service location.
 The setup sequence assumes that the CN3200 Modem device is in factory-default configuration
and has not been previously configured.
IMPORTANT: BEFORE YOU CONTINUE
Antennas or dummy loads MUST be connected to the two top Tx RF ports.
Both top Tx RF ports MUST be properly terminated
before power is applied to the unit.
Applying power without proper RF port termination
might damage the unit
and void the product warranty.
The CN3200 Dual Band Routing Modem is powered through the Ethernet cable. PoE (Power-over-
Ethernet) is a standardized system which passes electrical power along with data on Ethernet
cabling.
After terminating the Tx RF ports, connect the provided PoE++ Power Supply as shown:
DO NOT plug the power cord into the AC outlet until directed.
110-240 VAC,
50/60 Hz
PoE++
Power
Supply
PoE Surge
Protector
ETHERNET DATA
POWER plus DATA
GROUND