User's Manual

Once communication with the Xeta7 has been established using the serial

communications interface, the standard menu based prompt will be displayed. Using

this interface, the radio can be controlled and the following parameters can be

configured:

Operation Reference Map

0: Main Configuration Menu

0: Serial Menu

0: Set Data Serial Bit Rate

1: Set Data Serial Framing

2: Set Data Serial Protocol

3: Set Baud Clock Multiplier

4: Set Data Serial flow control

5: Set Serial message delay

6: Set Data Serial interface (RS232, 422, 485)

7: Set RS485 after delay

8: Set RS485 before delay

9: Set seamless group

1: RF and Hopping Menu

0: RF Band (Fixed)

1: Set Maximum separation

2: Set RF Transmit Power

3: Set RF Master Transmit Frequency

4: Set RF Slave Transmit Frequency

2: Bit Rate and Modulation type Menu

0: Toggle between data rates and modulation methods

3: Network Menu

0: Set Operating Mode (Master; Slave; Repeater)

1: Set Network Type (M to S; M to R to S; M to xS)

2: Set Network Address (unique 9-digit value)

3: Set Upstream Device Address

4: Set Downstream Device Address

5: Set Maximum Payload Size, Master

6: Set Maximum Payload Size, Slave

7: Set Device Address

8: Set Radio name

4: Advanced Menu

0: Set Multi-master sync mode

1: Set Idle beacon period

2: Toggle Dynamic payload mode

5: Utilities Menu