User's Manual

8
In order to power the radio, 7.5V +/- 10% DC must be applied across pins 7 and 10.
Communicating with the XETA7 using a serial interface terminal
Bits per Second (Baud): 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
The computer’s serial port must be configured by the user to match this configuration to
communicate. Once the radio is connected to the computer, power may be applied to
the radio resulting in the following initialization or boot sequence information being
displayed on the terminal:
spi_init(SPI_BUS_0)
spi_init(SPI_BUS_1)
twi_init()
iox_init()
pll_init(TRUE)
interrupt_init()
timer_init()
mon_init()
Xetawave Bootloader revision 1.17.1410 for rev 5 board
Booting . . .
spi_init(SPI_BUS_0)
spi_init(SPI_BUS_1)