User's Manual

10
After the initialization information appears, the operating menu will be displayed.
Operating Menu
If the characters are garbled, or nothing is displayed, then it is likely that the user’s serial
port does not match the radio’s serial port or the proper converters may not be in use.
The radio is shipped from the factory configured for 115200 Baud. This value can be
configured differently by the factory upon customer request. If the radio has had
settings changed from the factory settings, then you may need to try different computer
baud rates to find the match with the radio.
This screen displays the current configuration of the radio. It is important to note the
third line, which shows the Mode (Master/Repeater/Slave) of the radio and the mating
radio on the other side of the link and the device addresses of the two radios making
the link. In the above example, the radio is a Slave unit (address 8) and will link with a
Master unit (address 1).
Options:
• Enter “0” to display the configuration settings and utilities menu.
• Enter “1” to refresh all displayed parameters to current values.
• Enter “2”to reset the packet rate success statistics to 100%.
• Enter “3” to turn on or off automatic refreshing of displayed parameters.
Configuration/Utilities Menu
From the Operating Menu, enter “0” to view the Configuration/Utilities menu.
Operating Menu
XETA4-TMFA rev 0, firmware 1.53.19108, SN E50243FC
Mode: Slave (8) to Master (1)
Frequency 450006250 Hz
Xmit mode 32QAM 51 Kbps Link state up
Recv mode 32QAM 51 Kbps RSSI -78 dBm
Fwd power 10000 mW Noise -132 dBm
Rev power 11 mW Xmit rate 22.5 Kbps
Supply 12000 mV Recv rate 0.0 Kbps
Amp temp 32 C Cur success 100.00%
Board temp 29 C Avg success 100.00%
0 : Enter configuration/utilities menu
1 : Update radio status
2 : Reset all statistics
3 : Enable or disable automatic status updates
Enter selection: