User Guide

66
Chapter 4 Basic Machine Operations
Changing Output Roll Media for an Entire Job
By setting the [Size] on [Output Option] to [AUTO] (either [AUTO], [OTHER], [MIX]
or [MIX2]), the output paper is determined in accordance with the logical printer's
[Media mapping] table. If a paper mapping table is prepared for each job, it is possible to
change the output roll media for each job.
For example, if an A1 roll media and an A2 roll media are set in place and the A2 roll
media is to be used for printing out the A2 size [Job1] job and the A1 roll media to be
used for printing out [Job2], which is also in A2 size, the mapping table is set up as
follows.
In this example, [Job1] has been specified to use logical printer [PLT01H], which will
output the job on the A2 roll media.
[Job2] has been specified to use logical printer [PLT02H] and rotate the job by 90
degrees to print it out on the A1 roll media.
Refer to the "Size and Media Mapping" section of "4.5 Logical Printer Settings" for
details on available functions (page 103).
[PLT02H] logical printer settings
[PLT01H] logical printer settings
Image Size Media Size
A0 A0
A1 A1
A2 A1
A3 A3
A4 A3
Image Size Media Size
A0 A0
A1 A1
A2 A2
A3 A3
A4 A4
J
ob2
J
ob1
A2
A2
Logical printer
[PLT01H] specified
Logical printer
[PLT02H] specified
Rotated by
90 degrees
Output on the
A2 roll media
Output on the
A1 roll media