User Guide

44
Chapter 3 Setup
TCP/IP
1 Display [TCP/IP] on the setup item selection
screen, and then press the < > key.
2 Select the item that is to be set up with the use of
the < > and < > keys, and then press the
<> key.
[Ethernet Setting], [Default Parser], [IP
Address], [Mask Value], [E-Net Address],
[Dynamic Routing], and [Static Routing] will be
displayed in this order.
3 Select the parameters with the use of the < >
and < > keys, and then press the <Set> key.
An [*] mark will be displayed on the right-hand
side of the parameters once they have been set.
1. Move the cursor to the left and the right with
the use of the < > and < > keys.
2. Select the required value with the use of the
< > and < > keys. The value will increase
or decrease sequentially between 0 and 9.
3. Press the <Set> key once all values have been
entered.
• Additions can be made to the routing
table when [Static Routing] is enabled.
• The [E-Net Address] can only be
displayed, not changed.
• To proceed onto the next menu, move
the cursor to the right-hand side and
press the < > key.
• To return to the previous menu, move
the cursor to the left-hand side and
press the < > key.
PORT SETTING
TCP/IP
TCP/IP
Default Parser
Default Parser
HPGL *
IP Address
120. 000. 000. 000
IP Address
100. 000. 000. 000
IP Address
123. 123. 123. 001 *
Entering addresses