User Guide

41
3.1 Setting up Communication Parameters
Centronics (optional)
The following communication parameters need to be set up.
VPI (optional)
The following communication parameters need to be set up.
Menu Item Description
Ack Mode The Ack mode is selected from [MODE0], [MODE1],
[MODE2], [MODE3], and [MODE7].
The default setting is [MODE0].
DMA Timeout The timeout value for data input is entered within a range of 1 to
255 seconds.
The default setting is [5 sec].
EOP Timeout The timeout value is entered within a range of 1 to 255 seconds.
The default setting is [10 sec].
Job Separation Sets the job separation. The default setting is [NO].
[YES] Starts conversion processing once the command
that recognizes the end of the data is received
even midway through the file.
[NO] Performs the spooling process on the hard disk
until a timeout is issued.
• If a value higher than [255] is entered for the timeout value, [255] will be set as the
value.
• Changes to the [Ack Mode] and [DMA Timeout] values will have not any effect on
operations.
Menu Item Description
REPORT
OFFLINE
Sets whether to issue the host with offline notification of paper
running out or not.
The default setting is [NO].
[YES] Issues offline notification.
[NO] Does not issue offline notification.
EOP Timeout The timeout value is entered within a range of 1 to 255 seconds.
The default setting is [10 sec].
Job Separation Sets the job separation. The default setting is [NO].
[YES] Starts conversion processing once the command that
recognizes the end of the data is received even
midway through the file.
[NO] Performs the spooling process on the hard disk until
a timeout is issued.
If a value higher than [255] is entered for the timeout value, [255] will be set as the
value.