User Guide

180
Chapter 6 Ethernet Print Service (for UNIX)
Message List
This section explains messages that may be displayed during printing using the ftp
command.
Status: Cannot establish connection for data transfer.
Action: Wait a few moments and try again.
Status: Cannot create a control file using the STOR command.
Action: Wait for some time and try again.
Status: Cannot create a job file using the LJ command.
Action: Wait for some time and try again.
Status: Cannot create a socket in passive mode.
Action: Wait for some time and try again.
Status: Cannot open a parameter file for creating the specified file.
Action: Wait for some time and try again.
Status: Command (XX) received not supported.
Action: Enter the correct command.
Status: A control connection error occurred in the FTP command wait status. Therefore, the
connection was disconnected.
Action: For another transfer, establish connection again.
Can't build data connection
Can't create control file, please try later
Can't create status file, please try later
Can't open passive connection
Cannot create file "xx" or permission problem
Command "xx" not understood
Control connection read error