User Guide

169
5.9 Power Save Mode
2 Select either [Low power mode 1], [Low power
mode 2] or [Sleep Mode] with the use of the
<> key.
3 Press the < > key.
4 Select the required parameters with the use of
the < > and < > keys, and then press the
<Set> key.
An [*] mark will be displayed on the right-hand
side of the value once it has been set.
The parameters become valid the
moment that the <Set> key is pressed. It
is therefore not necessary to save the
changes later.
SYSTEM PARAMETER
Low power mode1
< > key
Low power mode1
OFF
< > key
Low power mode1
ON *
< > key