User Guide

88
Chapter 4 Basic Machine Operations
End style
SQUARE
The normal method of ending lines.
ROUND
Rounds off both ends of the line with a half radius of the line
width.
EXTEND
Adds half of the line width in length to both ends of the line.
TRIANGLE
Adds a triangle that is half of the line width in length to both
ends of the line.
Joint style
UNJOINT
Does not join up the lines.
BEVEL
Joins the outside corner of one line to the outside corner of
the other line.
MITER
Extends the outside corners of both lines until they meet in a
miter.
ROUND
Rounds off the area where the two lines meet.
Half the line width Half the line wid
th
L
ine width
Half the line width Half the line wid
th
L
ine width
Half the line width Half the line wid
th
L
ine width