Operation Manual

10 Getting Started
Setup (continued)
7 Turn the WorkCentre power switch on. The switch is located on the rear
of the machine, next to the printer ports. Pressing the right, outer side
turns the power on; pressing the left, inner side turns the power off.
Power switch
8 The Control Panel Display will show 000 in a scrolling manner while
the machine is initializing.
9 The Control Panel Display will show 001 when it is ready for use.
Control Panel mode indicators are set to default values for this setup
procedure. When you first power the machine on and there are no
cartridges installed, you will see the error code E02 shown in the
Display. This means there is no left (color) cartridge installed. This error
code will disappear when you start the next procedure.
10 Proceed to the next step Installing & Aligning Ink Cartridges.