Operation Manual

2.13
User Guide
PROGRAMMABLE FEATURE SETTINGS
2
Setting 10
Use the following procedure to change the
preset Reduction/Enlargement default
setting. This feature allows you to set a
specific preset reduction or enlargement
between 50-200%.
Select the Toner Saver by using the Copy
Quality button.
Press again and hold the Copy Quality button
for approximately 4 to 6 seconds.
• The light next to Auto will light.
• The lights within the WorkCentre
Diagram will flash.
Press the 10 button until the number 10 is
displayed.
Press Start. The current reduction/
enlargement setting will flash.
1
2
3
4
Xe88qrg.bk Page 13 Thursday, February 17, 2000 4:25 PM