User guide

5-96 Xerox WorkCentre C226 User Guide
Fax Unit
Information appearing in the TYPE/NOTE column
Information such as the type of transmission and type of error appears in the TYPE/
NOTE column of the Transaction Report or Activity Report. The following notes may
appear.
Note Explanation
OK The transaction was completed normally.
G3 Communication took place in G3 mode.
ECM Communication took place in G3 ECM mode.
SG3 Communication took place in Super G3 mode.
FW. The received data was forwarded.
NO RESPONSE No response from the receiving party.
BUSY Transmission was not possible because the other party was already using the
line.
CANCEL A transmission was cancelled while in progress, or a stored transmission job was
cancelled.
MEMORY OVER The memory became full during quick on-line transmission.
MEM. FULL The memory became full during reception.
LENGTH OVER The transmitted document was over 1500 mm (59") long and therefore could not
be received.
ORIGINAL ERROR Manual transmission was not successful because a jam occurred.
PASS# NG The connection was broken because the polling passcode was not correct.
NO RX POLL The machine that was polled does not have a polling function.
RX POLL FAIL The other machine refused the polling operation, or your machine broke the con-
nection when polled because no data was in memory.
NO F-CODE POLL The other machine refused an F-code polling operation, or your machine broke
the connection when polled because no data was in its F-code memory polling
box.
RX POLL# NG Your machine broke the connection because the other machine specified an F-
code polling sub-address that does not exist in your machine.
F PASS# NG Your machine broke the connection because an incorrect passcode was sent for
an F-code transmission.
BOX NO. NG Your machine broke the connection because the specified sub-address for an F-
code memory box does not exist.
F POLL PASS# NG Your machine broke the connection because the other machine sent an incorrect
passcode for F-code polling.
RX NO F-CODE POLL F-code polling was attempted, however, the other machine did not have an F-
code polling memory box.