User guide

5-84 Xerox WorkCentre C226 User Guide
Fax Unit
9. Touch the [OK] key.
You will return to the memory box programming screen.
The entered sub-address and passcode are displayed.
"REGISTRATION IS COMPLETED." appears to the right
of the box number. (Only for F-Code polling memory.)
Continue programming the settings that are particular to each type of memory box. Go
to the appropriate page below:
• F-code polling memory (Polling times: page 5-84)
• F-code confidential transmission (Print PIN: page 5-85)
• F-code relay broadcast transmission (Recipient: page 5-86)
Setting for F-Code Polling Memory Boxes (Polling Times)
You can select whether to have document data that was scanned into an F-code poll-
ing memory box automatically cleared after one transmission, or to leave the docu-
ment data in the box and allow an unlimited number of transmissions when polled.
(The initial setting is "ONCE". Change the setting as needed.)
1. Touch the [POLLING MEMORY] key in step 3 of “Programming an F-Code
Memory Box” on page 5-82 and store a box name, sub-address, and passcode.
2. Touch the [POLLING TIMES] key.
3. Touch the key for the desired polling times.
If you do not wish to erase the document after polling takes place, touch the
[UNLIMITED] key so that it is highlighted.
OkCancel
-Key Pad,Then Press [Ok].
Pass Code
Sub Address
Box Name
Marketing Group
Once
214341434/351212
Polling Times
F-Code Memory Box / Polling Memory
Polling Times
No.001
Once
Unlimited
Exit
Ok
Next