User guide

Programming, Editing, and Deleting F-Code Memory Boxes
Xerox WorkCentre C226 User Guide 5-81
1. Press the [CUSTOM SETTINGS] key, and then touch the [ADDRESS CONTROL]
key (refer to steps 1 and 2 on page 5-67).
2. Touch the [CUSTOM INDEX] key.
3. Touch an index key ([USER 1] to [USER 6]).
You can enter a name for the selected index.
When touched, the letter entry screen appears.
4. Enter a maximum of 6 characters for the index name.
Use the key to clear the displayed name and then enter the desired name.
Refer to page 5-90 for the procedure for entering letters.
When finished, touch the [OK] key. The new name appears in the screen of step 3.
5. If you wish to program another index name, repeat steps 3 and 4.
When finished, touch the [OK] key.
To change a user index name, re-enter the name as explained in steps 3 and 4.
Programming, Editing, and Deleting F-Code Memory Boxes
The procedure for programming a memory box for F-code transmission is explained
here. There are three types of F-code memory boxes: F-code polling memory (page 5-
52), F-code confidential transmission (page 5-56), and F-code relay broadcast
(page 5-59). Memory boxes are programmed, edited, and deleted as follows.
Direct Address / Program
Custom Index
F-Code Memory Box
Custom Settings
Custom Index
Select The Key To Be Custom Named.
Ok
User 1 User 2 User 3 User 4 User 5 User 6