User guide

Transmission and Reception Using the Polling Function
Xerox WorkCentre C226 User Guide 5-37
4. When you have finished entering the destination(s), press the [BLACK COPY
START] key.
"JOB STORED." appears in the touch panel.
The fax is received from the other machine and printed
out.
NOTE: To cancel the operation
Press the [JOB STATUS] key and then cancel the operation. (See “Cancelling a Fax
Transmission” on page 5-27.)
Manual Polling
A document should not be loaded in the machine when the following operation is per-
formed. Manual polling is begun on the signal of the other party.
1. Touch the [SPEAKER] key in fax mode, and dial the number of the other machine.
A one-touch key or the [REDIAL] key can also be used.
2. Touch the [SPECIAL MODES] key.
If the address directory screen appears, touch the [CON-
DITION SETTINGS] key to display the condition settings
screen.
3. When you hear the fax tone from the other machine, touch the [POLLING] key.
"JOB STORED." appears in the touch panel.
Polling reception begins.
Your machine prints the fax after receiving it from the sending machine.
NOTE: Serial polling cannot be performed manually. When polling reception ends, repeat
steps 1 through 4.
Fax Memory:100%
Auto Reception
Addr
Dire
Sub
Re
Speaker
Add
Dire
Sub Ad
Address Special Modes
Auto Reception
Polling
er
Program
l Page
Scan