Manualshelf

Installation Guide

ManualsBrandsXerox ManualsAll in One PrinterXerox WorkCentre 7525/7530/7535/7545/7556 with built-in controller
21222324252627282930
Installation
Xerox® Smart Card
Installation Guide
25
Using the Smart Card
Once the Smart Card has been enabled, each user must insert a valid card and enter their Personal
Identification Number (PIN) on the touch screen. When a user has finished using the Xerox device,
they are then required to remove their card from the card reader to end the session. For instances
where a user forgets to remove their card, the machine will end the session automatically after a
specified period of inactivity.
Follow the instructions below to use the Smart Card:
1. The Authentication Required window may be displayed on the touch screen, depending on your
device configuration.
2. Insert your card into the card reader.
3. Use the touch screen and numeric keypad to enter your PIN and then select Enter.
4. If the card and PIN are authenticated, access is granted.
Note: If the access attempt fails, refer to Troubleshooting Tips on page 29.
5. Complete the job.
6. To end the session, remove your card from the card reader.
The current session is terminated and the Authentication Required window is displayed.