Operation Manual

Paper and Media WorkCentre
®
5845/5855/5865/5875/5890
User Guide 637
The tray can feed a range of media weights and types.
• Up to 1600 sheets of 75 gsm (20 lb) paper.
• The media weight range is from 60 (16 lb) to 200 gsm (53 lb).
Note: For 80 gsm paper capacities are slightly lower than specified.
Note: Your device does not warn you if the wrong sized media is loaded.
It is important to select the correct Type for the media loaded in the tray. The device can detect
different types of media as each page travels through the paper path and will halt a job if a
mismatch occurs.
Only use the types of media specified for use in the tray.
•Plain
•Bond
•Recycled
•Punched
• Letterhead and Pre-printed
•Rough Surface
•Glossy
•Cardstock
• Lightweight Cardstock
This tray must not be used to feed labels, transparencies or envelopes. The Bypass Tray can be used
for these media types. The optional Envelope Tray can be used in place of Tray 2 for envelopes.
CAUTION: A problem will occur if a tray is opened while it is being used to feed media.
1. Open the tray.
2. Place the media in the tray. Media must be positioned against the left side of the tray.
Paper must not be loaded above the maximum fill line.
• Load pre-printed paper face-down and with the top towards the front of the device.
• Load hole punched paper with the holes on the left edge.
3. Close the paper tray.
More Information
Storing Paper and Other Media
Loading Different Types of Media
Using Internet Services to find System Administrator Contact Details