Operation Manual

Fax WorkCentre
®
5845/5855/5865/5875/5890
User Guide 135
Use the Original Size options to select automatic size detection of the originals, specify the sizes of
mixed size originals, or specify the exact size of an image to be scanned.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Fax button on the touch screen.
5. If required, select the Fax tab. This is usually the active tab when the Fax service opens.
6. Select the Enter Fax Number entry box and use the numeric keypad, or the touch screen
keypad to enter the recipient’s fax number.
7. Select the Add button.
• If you want to send the document to more than one recipient enter the additional details,
one recipient at a time, and select the Add button again until all the recipients have been
added.
8. Select the Close button to save the information you entered.
9. Select the Layout Adjustment tab.
10. Select the Original Size button.
11. Select the Original Size option required.
• Auto Detect enables automatic size sensing, this is the default setting. The size detected
is matched to a standard paper size.
• Preset Scan Area defines the size of your original from a list of preset, standard original
sizes. You can view the list by using the scroll bar.
• Custom Scan Area sets a specific area for scanning and is useful for scanning receipts.
Measure the width (X) and height (Y) of the original to be scanned and enter the X and Y
measurements into the fields provided.
• Mixed Size Originals scans documents containing different sized pages. The pages must
be the same width, such as A4 (8.5 x 11”) LEF and A3 (11 x 17”) SEF, other combinations
are shown on the device touchscreen. The device detects the size of the documents and
will produce different output depending on the combinations selected.
12. Select the OK button.
13. Press the Start button on the control panel to scan the original.
14. Remove the original from the document feeder or document glass when scanning has
completed.
15. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
More Information
Faxing Book Pages (Embedded Fax)
Setting a Fax to Reduce Size or Split when Received (Embedded Fax)
Using a User ID to Log In at the Device
Explaining the Fax Options
Using Internet Services to find System Administrator Contact Details
System Administrator Guide www.xerox.com/support.