Operation Manual

5 Network Scan
58 Xerox WorkCentre 4150 User Guide
2. Select Network Scanning on the touch screen. Ensure that the Network
Scanning screen is displayed.
NOTE: If the Authentication feature is enabled, you may need an account
number before using the machine. To get an account number, or for more
information, contact the Key Operator or the System Administrator.
3 Select Network Scanning Template
Network Scanning uses preset templates created by the System
Administrator. These templates already contain feature settings customized
to the user. Use the up/down scroll buttons located to the right of the
Template List on the Network Scanning tab to move through the list one page
at a time and select a Template.
To get quickly to a specific page in the Template list, use the number keypad
to identify the page number then select the pound (#) key. The counter will
display the page location.
For more information on Scanning templates, refer to Network Scanning in the
Network Scan chapter on page 62.
4 Change Feature Settings
To temporarily change the template settings, perform the following:
1. Press the Clear All button once on the control panel to cancel any
previous selections. The control panel returns to the default Entry
screen.
2. Select the button for the feature required.
Feature Description
Network Scanning
Use this feature to select the required template.
Basic Settings
Use this feature to temporarily change the information
relating to your original, e.g. color scanning, 2 sided
originals, scan presets, etc.