User manual

Service · Checking the Firmware Version¦ 83
EN
Checking the Firmware Version
1. Press OK, 47 and OK.
2. The model designation and the configured country appear on the display.
3. Confirm with OK.
4. The information on the firmware version of the device is displayed.
5. Confirm with OK.
Using Service Codes
Introduction
The service codes delete all the changed settings and your device is reset to factory settings.
It may be possible that the device with the changed settings reacts differently than expected.
Using Service Codes
1. Press OK, 45 and OK.
2. Enter a service code:
7117—Deletes all changed settings and saved data. The device is reset to fac-
tory settings and the initial installation process is started.
7140—Deletes all changed settings. Saved data and telephone book entries
remain intact.
7227—Deletes saved faxes, when there are problems with printing.
3. Confirm with OK.
4. Using [ select
SURE: YES.
5. Confirm with OK.
Power Cycling
If a problem occurs that cannot be corrected with the instructions in this user manual (see
also the help below), follow the steps given here.
1. Pull out the power plug.
2. Wait at least ten seconds, then plug the power plug back into the socket.
3. Follow the instructions on the display and in the error report. If the problems repeats,
please contact our technical customer service or your retailer.
CAUTION!
Settings will be Deleted!
Only use the service codes if this is absolutely necessary. Some service codes also de-
lete saved messages and telephone book entries.
Notice
Cancelling Entry
If you have entered the incorrect code, you can cancel the entry with
SURE:
NO
.