User manual

Service · Changing the Ink Film¦ 77
EN
5. Pull the used Plug’n’Print card out of the plug socket on the left hand side next to the
ink film tray. The Plug’n’Print card cannot be reused.
6. Carefully remove the rubber bands from the new ink film. Make sure that the film is not
damaged!
7. Place the larger roll with the ink film in the rear ink film tray. The blue gear wheel must
be on the right hand side.
8. Place the smaller roll without ink film in the front tray. The blue gear wheel must be on
the right hand side and the pin must be inserted in the depression on the left hand side.